Spectrum Analyzer Commands :MEASure Subsystem
MS20xxC PM PN: 10580-00306 Rev. E 6-43
Measure Channel Power Density
:MEASure:CHPower:DENSity?
Description: Sets the active measurement to channel power, sets the default
measurement parameters, triggers a new measurement and returns the
channel power density result. To measure both channel power and
channel power density use :MEASure:CHPower? It is a combination of
the commands :CONFigure:CHPower; :READ:CHPower:DENSity?
For a description of the default channel power measurement
parameters, refer to :CONFigure:CHPower. To make a channel power
measurement with settings other than the default values send:
:CONFigure:CHPower
Commands to set desired settings
:READ:CHPower:DENSity?
Syntax: :MEASure:CHPower:DENSity?
Cmd Parameter: NA (query only)
Default Unit: Current amplitude units
Related Command: :MEASure:CHPower?
:MEASure:CHPower:CHPower?
:CONFigure:CHPower
Front Panel
Access: NA
To Next Page
Loading...
