All Mode Commands :MMEMory:MSIS Subsystem
MS20xxC PM PN: 10580-00306 Rev. E 8-7
8-5 :MMEMory:MSIS Subsystem
The Mass MEMory “Mass Storage IS” subsystem contains commands for selecting a mass
storage device that is used by all of the :MMEMory commands.
Storage Location
:MMEMory:MSIS
Description: Sets the storage location. Setting the storage location to INTernal sets
the current storage location to be the internal memory. Setting the
storage location to USB sets the current storage location to be the USB
Flash drive. Note that changing the current location to save files causes
the “Copy to Destination” on the front panel to be automatically
changed if the selected current location is the same as the destination.
When the change occurs, the instrument cycles through each of the
available storage locations.
Note that the storage location can be set independently and can be
different for remote operation and front panel operation. Changing the
copy location remotely does not change the location that is set and
displayed on the front panel. Similarly, changing the copy location via
the front panel does not affect the location that is used by the remote
operation commands.
Note that the storage location must be available in order for it to be set.
Syntax: :MMEMory:MSIS INTernal|USB
:MMEMory:MSIS?
Cmd Parameter: <char> INTernal|USB
Query Response: <char> INT|USB
Related Command: :MMEMory:MSIS:DESTination
Front Panel
Access: NA
Copy From Current Location To Destination
:MMEMory:MSIS:COPY
Description: Copies all measurements, setups, and *.jpg files that are stored in
the current storage location to the “copy to destination” location.
Syntax: :MMEMory:MSIS:COPY
Cmd Parameter: NA
Query Response: NA (no query)
Related Command: :MMEMory:MSIS
:MMEMory:MSIS:DESTination
Front Panel
Access: NA
To Next Page
Loading...
