VNA Commands [:SENSe] Subsystem
MS20xxC PM PN: 10580-00306 Rev. E 3-101
3-19 [:SENSe] Subsystem
The commands in this subsystem relate to device-specific parameters, not to signal-oriented
parameters.
Table 3-5. [:SENSe] Subsystem
Keyword Parameter Data or Units
[:SENSe]
:APPLication Refer to “[:SENSe]:APPLication Subsystem” on page 3-102
:AVERage Refer to “[:SENSe]:AVERage Subsystem” on page 3-103
:CALibration Refer to “[:SENSe]:CALibration Subsystem” on page 3-104
:CORRection Refer to “[:SENSe]:CORRection Subsystem” on page 3-105
:FREQuency Refer to “[:SENSe]:FREQuency Subsystem” on page 3-136
:RFON[:STATe] Refer to “[:SENSe]:RFON[:STATe] Subsystem” on page 3-141
:SWEep Refer to “[:SENSe]:SWEep Subsystem” on page 3-143
:TRACe Refer to “[:SENSe]:TRACe Subsystem” on page 3-145
To Next Page
Loading...
