:ABORt Subsystem Spectrum Analyzer Commands
6-2 PN: 10580-00306 Rev. E MS20xxC PM
6-2 :ABORt Subsystem
The abort subsystem includes commands that allow the user to stop current measurement
activities on the instrument.
:ABORt
Description: Restarts the current sweep and/or measurement. Resets the trigger
system. If :INITiate:CONTinuous is OFF (in other words, the
instrument is in single sweep mode), then send the command
:INITiate[:IMMediate] to trigger the next sweep. If
:INITiate:CONTinuous is ON (in other words, the instrument is in
continuous sweep mode), then a new sweep starts immediately.
Syntax: :ABORt
Parameter: NA
Query Response: NA (no query)
Related Command: :INITiate:CONTinuous
:INITiate[:IMMediate]
Front Panel
Access: NA
To Next Page
Loading...
