Anritsu MS2026C - Marker (Maximum) Peak Search; Marker (Maximum) Peak Search Left; Marker (Maximum) Peak Search Next

Spectrum Analyzer Commands :CALCulate Subsystem
MS20xxC PM PN: 10580-00306 Rev. E 6-25
Marker (Maximum) Peak Search
:CALCulate:MARKer{1|2|3|4|5|6}:MAXimum
Description: Puts the specified marker at the maximum amplitude in the trace.
Syntax: :CALCulate:MARKer{1|2|3|4|5|6}:MAXimum
Front Panel
Access: Marker, Marker [1/2/3/4/5/6], Peak Search
Marker, Marker [1/2/3/4/5/6], More Peak Options, Peak Search
Marker (Maximum) Peak Search Left
:CALCulate:MARKer{1|2|3|4|5|6}:MAXimum:LEFT
Description: Puts the specified marker on the next highest peak to the left of the
current peak. The next highest peak must be above the peak threshold.
If no point meets that criterion, the marker is set to the first point on
the trace.
Syntax: :CALCulate:MARKer{1|2|3|4|5|6}:MAXimum:LEFT
Related Command: :CALCulate:MARKer:PEAK:THReshold
Front Panel
Access: Marker, More Peak Options, Next Peak Left
Marker (Maximum) Peak Search Next
:CALCulate:MARKer{1|2|3|4|5|6}:MAXimum:NEXT
Description: Moves the marker to the highest peak anywhere in the trace which is
lower than the current marker. If the given marker is not on, the
command turns it on and sets it to the second highest peak in the trace.
The command uses the existing peak threshold values to determine
what is a peak and what is not.
Syntax: :CALCulate:MARKer{1|2|3|4|5|6}:MAXimum:NEXT
Related Command: :CALCulate:MARKer:PEAK:THReshold
Front Panel
Access: None