Anritsu MS2026C - Calibration Correction State

VNA Commands [:SENSe]:CORRection Subsystem
MS20xxC PM PN: 10580-00306 Rev. E 3-107
Calibration Correction State
[:SENSe]:CORRection[:STATe]
Description: Turns the calibration error correction ON or OFF. Note that error
correction can be turned ON only if valid calibration is available.
Syntax: [:SENSe]:CORRection[:STATe] OFF|ON
[:SENSe]:CORRection[:STATe]?
Parameter: OFF|ON
Cmd Parameter: <boolean> OFF|ON|0|1
Query Response: <bNR1> 0|1
Default Value: 0
Front Panel
Access: Shift-2 (Calibrate), Cal Correction