Anritsu MS2026C - Delete Limit Point; Next Point Left; Next Point Right

:CALCulate Subsystem Spectrum Analyzer Commands
6-10 PN: 10580-00306 Rev. E MS20xxC PM
Delete Limit Point
:CALCulate:LIMit:POINt:DELete
Description: Deletes the currently active limit point. The active point becomes the
point that is immediately to the left of the point that was deleted. Note
that deletion is only valid if there are more than 2 limit points. Use
:CALCulate:LIMit:TYPe to set the currently active limit line.
Syntax: :CALCulate:LIMit:POINt:DELete
Example: To delete the currently active limit point:
:CALCulate:LIMit:POINt:DELete
Front Panel
Access: Shift-6 (Limit), Limit Edit, Delete Point
Next Point Left
:CALCulate:LIMit:POINt:LEFT
Description: Selects the limit point immediately to the left of the active point,
making it active for editing or deleting. Use :CALCulate:LIMit:TYPe
to set the currently active limit line.
Syntax: :CALCulate:LIMit:POINt:LEFT
Example: To select the point to the left of the active point:
:CALCulate:LIMit:POINt:LEFT
Front Panel
Access: Shift-6 (Limit), Limit Edit, Next Point Left
Next Point Right
:CALCulate:LIMit:POINt:RIGHt
Description: Selects the limit point immediately to the right of the active point,
making it active for editing or deleting. Use :CALCulate:LIMit:TYPe
to set the currently active limit line.
Syntax: :CALCulate:LIMit:POINt:RIGHt
Example: To select the point to the right of the active point:
:CALCulate:LIMit:POINt:RIGHt
Front Panel
Access: Shift-6 (Limit), Limit Edit, Next Point Right