Anritsu MS2026C - Marker Frequency to Center; Marker to Reference Level; Marker State

:CALCulate Subsystem Spectrum Analyzer Commands
6-28 PN: 10580-00306 Rev. E MS20xxC PM
Marker Frequency to Center
:CALCulate:MARKer{1|2|3|4|5|6}[:SET]:CENTer
Description: Sets the center frequency equal to the frequency of the specified marker.
Note that this results in a change to the start and stop frequencies and
may also result in a change to the span. Note that this command is not
valid in zero span.
Syntax: :CALCulate:MARKer{1|2|3|4|5|6}[:SET]:CENTer
Front Panel
Access: Marker, Marker Freq to Center
Marker to Reference Level
:CALCulate:MARKer{1|2|3|4|5|6}[:SET]:RLEVel
Description: Sets the reference level equal to the measured amplitude of the
specified marker. Note that this may result in a change to the input
attenuation.
Syntax: :CALCulate:MARKer{1|2|3|4|5|6}[:SET]:RLEVel
Front Panel
Access: Marker, Marker to Ref Lvl
Marker State
:CALCulate:MARKer{1|2|3|4|5|6}[:STATe]
Description: Sets the specified marker on/off.
Syntax: :CALCulate:MARKer{1|2|3|4|5|6}[:STATe] OFF|ON|0|1
:CALCulate:MARKer{1|2|3|4|5|6}[:STATe]?
Cmd Parameter: <boolean> OFF|ON|0|1
Query Response: <bNR1> 0|1
Default Value: OFF
Example: To turn off reference marker #1:
:CALCulate:MARKer1:STATe OFF
Front Panel
Access: Marker, On/Off