Anritsu MS2026C - Gate Stop Distance

:CALCulate<Tr>:FILTer[:GATE]:DISTance Subsystem VNA Commands
3-12 PN: 10580-00306 Rev. E MS20xxC PM
Gate Stop Distance
:CALCulate<Tr>:FILTer[:GATE]:DISTance:STOP
Description: Sets the gate stop distance for the given trace. <Tr> is the trace
number in the range of 1 to 4. If no trace number is specified, then the
<Tr> parameter defaults to trace number 1. The query version of this
commands returns the current gate stop distance in millimeters. Note
that setting this may also change the gate span, start, and center for
both time and distance gates. If gate coupling is on, then setting the
gate stop distance also sets the same gate stop distance for all traces.
Note that setting this also sets the given trace as the active trace if it is
not already active.
Note that the command
:CALCulate<Tr>:FILTer[:GATE]:TIME:STOP functions the same
as this command. The only difference is that with this command, you
must send the stop in distance units rather than time units.
Syntax: :CALCulate<Tr>:FILTer[:GATE]:DISTance:STOP
<stop distance>
:CALCulate<Tr>:FILTer[:GATE]:DISTance:STOP?
Cmd Parameter: <NRf> <stop distance>
Query Response: <NR3> <stop distance>> (returned in millimeters)
Range: –3000.0 m to +3000 m
Default Value: 5480 mm
Default Unit: Meters (m) when setting. Millimeters (mm) for query. Note that if the
distance unit is in feet, then both setting and query are in feet.
Example: To set the gate stop distance for Trace 4 to 10 meter:
:CALC4:FILT:GATE:DIST:STOP 10
Related Command: :CALCulate<Tr>:FILTer[:GATE]:TIME:STOP
Front Panel
Access: Freq/Time/Dist, Gate, Stop Gate