Anritsu MS2026C - Video Bandwidth; Video Bandwidth Coupling

[:SENSe] Subsystem Spectrum Analyzer Commands
6-72 PN: 10580-00306 Rev. E MS20xxC PM
Video Bandwidth
[:SENSe]:BANDwidth|BWIDth:VIDeo
Description: Sets the video bandwidth. Note that using this command turns the
automatic video bandwidth setting OFF.
Syntax: [:SENSe]:BANDwidth|BWIDth:VIDeo <freq>
[:SENSe]:BANDwidth|BWIDth:VIDeo?
Cmd Parameter: <freq>
Query Response: <freq>
Range: 1Hz to 3MHz in a 1:3sequence
Default Value: 1MHz
Default Unit: Hz
Related Command: [:SENSe]:BANDwidth|BWIDth:VIDeo:AUTO
Front Panel
Access: BW, VBW
Video Bandwidth Coupling
[:SENSe]:BANDwidth|BWIDth:VIDeo:AUTO
Description: Sets the state of the coupling of the video bandwidth to the resolution
bandwidth. Setting the value to ON or to 1 results in the video
bandwidth being coupled to the resolution bandwidth. That is, when the
resolution bandwidth changes, the video bandwidth changes. Setting
the value to OFF or to 0 results in the video bandwidth being uncoupled
from the resolution bandwidth. That is, changing the resolution
bandwidth no longer changes the video bandwidth. When this command
is issued, the video bandwidth setting itself does not change, only the
coupling is affected. The default value is ON. That is, sending
:SENS:BAND:VID:AUTO is equivalent to sending
:SENS:BAND:VID:AUTO ON.
Syntax: [:SENSe]:BANDwidth|BWIDth:VIDeo:AUTO OFF|ON|0|1
[:SENSe]:BANDwidth|BWIDth:VIDeo:AUTO?
Cmd Parameter: <boolean> OFF|ON|0|1
Query Response: <bNR1> 0|1
Default Value: ON
Front Panel
Access: BW, Auto VBW