MS20xxC PM PN: 10580-00306 Rev. E 7-1
Chapter 7 — AM/FM/PM Commands
7-1 Introduction
This chapter describes commands for AM/FM/PM Analyzer mode. Only the commands that
are listed in this chapter and in Chapter 8, “All Mode Commands” can be used in AM/FM/PM
Analyzer mode. Using commands from other modes may produce unexpected results.
Notational conventions are described in Section 2-10 “Command and Query Notational
Conventions” on page 2-12.
AM/FM/PM Analyzer Commands
Table 7-1. SPA Commands Subsystems
Keyword Parameter Data or Units
:CALCulate “:CALCulate Subsystem” on page 7-2
:DISPlay “:DISPlay Subsystem” on page 7-6
:FORMat “:FORMat Subsystem” on page 7-7
:INITiate “:INITiate Subsystem” on page 7-9
:MMEMory “:MMEMory Subsystem” on page 7-10
:TRACe “:TRACe Subsystem” on page 7-13
[:SENSe] “[:SENSe] Subsystem” on page 7-14
To Next Page
Loading...
