Spectrum Analyzer Commands :MEASure Subsystem
MS20xxC PM PN: 10580-00306 Rev. E 6-45
Measure Occupied Bandwidth
:MEASure:OBWidth?
Description: Sets the active measurement to occupied bandwidth, sets the default
measurement parameters, triggers a new measurement and returns the
occupied bandwidth, percent of power and dB down results. It is a
combination of the commands :CONFigure:OBWidth;
:READ:OBWidth? For a description of the default occupied bandwidth
measurement parameters, refer to :CONFigure:OBWidth. To make
an occupied bandwidth measurement with settings other than the
default values send:
:CONFigure:OBWidth
Commands to set desired settings
:READ:OBWidth?
Data is returned as 3 comma-separated values: occupied bandwidth,
percent of power, dB down.
Syntax: :MEASure:OBWidth?
Cmd Parameter: NA (query only)
Default Unit: For OBW: Hz
For Percent of Power: %
For dB Down: dB
Related Command: :CONFigure:OBWidth
:CONFigure:RF SPECtrum
Front Panel
Access: NA
To Next Page
Loading...
