Spectrum Analyzer Commands :CALCulate Subsystem
MS20xxC PM PN: 10580-00306 Rev. E 6-9
Limit Line Type
:CALCulate:LIMit:LTYPe
Description: Sets the currently active limit line type. Absolutes limit lines set the
limit inflection points based upon the entered frequencies for each
point. Relative limit lines set the limit inflection points relative to the
current center frequency.
Syntax: :CALCulate:LIMit:LTYPe ABSolute|RELative
:CALCulate:LIMit:LTYPe?
Cmd Parameter: <char> ABSolute|RELative
Query Response: <char> ABS|REL
Range: ABSolute|RELative
Default Value: ABSolute
Example: To set the limit line type to relative:
:CALCulate:LIMit:LTYPe RELative
Related Command: :CALCulate:LIMit[:STATe]
Front Panel
Access: Shift-6 (Limit), Limit Advanced, Limit Line Type
Limit Mirror
:CALCulate:LIMit:MIRRor
Description: Creates a limit mirror. Use :CALCulate:LIMit:TYPe to set the
currently active limit line.
Syntax: :CALCulate:LIMit:MIRRor
Related Command: :CALCulate:LIMit:TYPe
Front Panel
Access: Shift-6 (Limit), Limit Advanced, Limit Mirror
Add Limit Point
:CALCulate:LIMit:POINt:ADD
Description: Adds a new limit point to the currently active limit line. Use
:CALCulate:LIMit:TYPe to set the currently active limit line.
Syntax: :CALCulate:LIMit:POINt:ADD
Related Command: :CALCulate:LIMit:TYPe
Front Panel
Access: Shift-6 (Limit), Limit Edit, Add Point
To Next Page
Loading...
