VNA Commands :SOURce:CORRection:RVELocity Subsystem
MS20xxC PM PN: 10580-00306 Rev. E 3-149
3-33 :SOURce:CORRection:RVELocity Subsystem
Commands in this subsystem deal with the parameters of the physical media of the Device
Under Test.
Propagation Velocity
:SOURce:CORRection:RVELocity
Description: Sets the propagation velocity of the cable for DTF measurements.
Syntax: :SOURce:CORRection:RVELocity <number>
:SOURce:CORRection:RVELocity?
Cmd Parameter: <NRf> <number> (unitless)
Query Response: <NR3> <number> (unitless)
Range: 0.001 to 1.0
Default Value: 1
Front Panel
Access: Freq/Time/Dist (or Freq), Domain Setup, Setup Distance, Additional
Dist Setup, Propagation Velocity
Cable Loss
:SOURce:CORRection:RVELocity:CABLoss
Description: Sets the cable loss for DTF measurements. The query version of this
command returns the cable loss in dB/m.
Syntax: :SOURce:CORRection:RVELocity:CABLoss <number>
:SOURce:CORRection:RVELocity:CABLoss?
Cmd Parameter: <NRf> <number> (unitless)
Query Response: <NR3> <number> (unitless)
Range: 0.0 to 5
Default Value: 0.0
Front Panel
Access: Freq/time/Dist (or Freq), Domain Setup, Setup Distance, Additional
Dist Setup, Cable Loss (when DUT Line Type is Coax)
To Next Page
Loading...
