MS20xxC PM PN: 10580-00306 Rev. E 5-1
Chapter 5 — Power Monitor
Commands
5-1 Introduction
This chapter describes commands for Power Monitor mode. Only the commands that are
listed in this chapter and in Chapter 8, “All Mode Commands” can be used in Power Monitor
mode. Using commands from other modes may produce unexpected results.
Notational conventions are described in Section 2-10 “Command and Query Notational
Conventions” on page 2-12.
5-2 Power Monitor Commands
Table 5-1. Power Monitor Commands Subsystems
Keyword Parameter Data or Units
:TRACe Refer to “:TRACe Power Monitor Subsystem” on page 5-2
:CALCulate
PMONitor Refer to “:CALCulate:PMONitor Subsystem” on page 5-5
:RELative Refer to “:CALCulate:PMONitor:RELative Subsystem” on page 5-7
:ZERO Refer to “:CALCulate:PMONitor:ZERO Subsystem” on page 5-8
:FETCh
PMONitor Refer to “:FETCh:PMONitor Subsystem” on page 5-9
:RELative Refer to “:FETCh:PMONitor:RELative Subsystem” on page 5-10
:ZERO Refer to “:FETCh:PMONitor:ZERO Subsystem” on page 5-11
To Next Page
Loading...
