Anritsu MS2026C - Trace Select

[:SENSe]:TRACe Subsystem VNA Commands
3-146 PN: 10580-00306 Rev. E MS20xxC PM
Trace Select
[:SENSe]:TRACe<Tr>:SELect
Description: Selects the given trace, <Tr>, as the active trace. <Tr> is the trace
number in the range 1 to 4. If no trace number is specified, then the
<Tr> parameter defaults to trace number 1. Note that this may also
change the total number of traces.
Syntax: [:SENSe]:TRACe<Tr>:SELect
Cmd Parameter: NA
Query Response: NA (no query)
Default Value: TR1
Example: To set trace 2 as the active trace:
:SENSe:TRACe2:SELect
:SENS:TRAC2:SEL
To set trace 1 as the active trace:
:SENSe:TRACe1:SELect
:SENSe:TRACe:SELect
Front Panel
Access: Measure, Active Trace