Anritsu MS2026C - Limit Point y Value

:CALCulate:LIMit Subsystem VNA Commands
3-38 PN: 10580-00306 Rev. E MS20xxC PM
Limit Point Y Value
:CALCulate:LIMit:POINt:Y
Description: Sets the location of the active limit point on the y-axis at the specified
location. Sending this command changes the Move Limit on the front
panel to Point if it is currently set to Limit. The <y-parameter> is
defined in the current y-axis. If no unit is specified with the
<y-parameter>, then the default unit is used. The query version of
the command returns the location of the active limit point on the y-axis.
If an error occurs, such as limit not ON, the query version of the
command returns an error code of –400. Limit line must be ON for the
command to be valid. Use :CALCulate:LIMit:TYPE to set the
currently active limit line.
Syntax: :CALCulate:LIMit:POINt:Y <y-parameter>
:CALCulate:LIMit:POINt:Y?
Cmd Parameter: <NRf> <y-parameter> (depends on display)
Query Response: <NR3> <y-parameter> (depends on display)
Default Unit: Current active trace y-axis unit
Related Command: :CALCulate:LIMit:POINt:X
:CALCulate:LIMit:TYPE
[:SENSe]:TRACe<Tr>:SELect
:CALCulate<Tr>:FORMat
Front Panel
Access: Shift 6 (Limit), Limit Edit, Amplitude