VNA Commands :CALCulate:LIMit Subsystem
MS20xxC PM PN: 10580-00306 Rev. E 3-49
Upper Limit Y Value
:CALCulate<Tr>:LIMit:UPPer:Y
Description: Sets the location of the upper limit line of the given trace <Tr> on the
y-axis at the given value. This moves the entire upper limit and moves
the current active limit point by the given value. <Tr> is the trace
number in the range 1 to 4. If no trace number is specified, then default
trace is trace number 1. The <y-parameter> is defined in the current
y-axis. If no unit is specified with the <y-parameter>, then the
default unit is used. The set version of the command changes the Move
Limit on the front panel to Limit if it is currently set to Point and sets
the given trace as the active trace. The query version of the command
returns the location of the active limit point on the y-axis. If an error
occurs, such as limit not ON, then the query version of the command
returns an error code of –400. Limit line must be on for the command to
be valid. Use :CALCulate:LIMit:TYPE to set the currently active
limit line.
Syntax: :CALCulate<Tr>:LIMit:UPPer:Y <y-parameter>
:CALCulate<Tr>:LIMit:UPPer:Y?
Cmd Parameter: <NRf> <y-parameter> (depends on display type)
Query Response: <NR3> <y-parameter> (depends on display type)
Default Unit: Current active trace y-axis unit
Related Command: :CALCulate:LIMit:TYPe
:CALCulate<Tr>:LIMit:UPPer:X
[:SENSe]:TRACe<Tr>:SELect
:CALCulate<Tr>:FORMat
Front Panel
Access: Shift 6 (Limit), Limit Edit, Amplitude
To Next Page
Loading...
