Anritsu MS2026C - S Parameter; Number of Traces

VNA Commands [:SENSe]:TRACe Subsystem
MS20xxC PM PN: 10580-00306 Rev. E 3-147
S Parameter
[:SENSe]:TRACe<Tr>:SPARams
Description: Defines the S-parameter for the given trace, <Tr>.
<Tr> is the trace number in the range 1 to 4. If no trace number is
specified, then the <Tr> parameter defaults to trace number 1. The
query version of this command returns “S11” if the S-parameter is set
to S11, “S21” if set to S21, “S12” if set to S12, “S22” if set to S22,
“SD1D1” if set to SD1D1, “SC1C1” if set to SC1C1, “SC1D1” if set to
SC1D1, and “SD1C1” if set to SD1C1.
Note that S-parameter S
D1D1
, S
C1C1
, S
C1D1
, and S
D1C1
are available
only if option 77 is installed.
Syntax: [:SENSe]:TRACe<Tr>:SPARams
S11|S21|S12|S22|SD1D1|SC1C1|SC1D1|SD1C1
[:SENSe]:TRACe<Tr>:SPARams?
Cmd Parameter: <char> [S11|S21|S12|S22|SD1D1|SC1C1|SC1D1|SD1C1]
Query Response: <char> [S11|S21|S12|S22|SD1D1|SC1C1|SC1D1|SD1C1]
Default Value: Trace 1: S
11
Trace 2: S
12
Trace 3: S
21
Trace 4: S
22
Example: To assign S
11
to trace 2:
:SENSe:TRACe2:SPARams S11
Front Panel
Access: Measure, S Parameter
Number of Traces
[:SENSe]:TRACe:TOTal
Description: Sets the number of traces to display.
Syntax: [:SENSe]:TRACe:TOTal <integer>
[:SENSe]:TRACe:TOTal?
Cmd Parameter: <char> [1|2|3|4]
Query Response: <char> [1|2|3|4]
Range: 1to4
Default Value: 4
Example: To set number of traces to 3:
:SENSe:TRACe:TOTal 3
Front Panel
Access: Measure, Number of Traces