Anritsu MS2026C - Fetch Occupied Bandwidth Frequency; Fetch Occupied Bandwidth

:FETCh Subsystem Spectrum Analyzer Commands
6-36 PN: 10580-00306 Rev. E MS20xxC PM
Fetch Occupied Bandwidth Frequency
:FETCh:OBWidth:FREQuency?
Description: Returns the most recent occupied bandwidth lower frequency and upper
frequency.
Data is returned as 2 comma-separated values: lower frequency and
upper frequency in Hz.
Syntax: :FETCh:OBWidth:FREQuency?
Cmd Parameter: NA (query only)
Default Unit: Hz
Related Command: :FETCh:CHPower?
:FETCh:CHPower:CHPower?
Front Panel
Access: NA
Fetch Occupied Bandwidth
:FETCh:OBWidth?
Description: Returns the most recent occupied bandwidth measurement
results: occupied bandwidth, percent of power, and dB down. One of
either percent of power or dB down is measured, and the other is set.
That is determined by the value that is set using
[:SENSe]:OBWidth:METHod. If the instrument is sweeping, then it
does not return until the sweep is complete. If the instrument is not
sweeping, and if the current data is not valid, then it returns
error –230. This could occur if an *RST command were issued
immediately before the :FETCh?, or if a measurement parameter
were changed without an :INITiate.
Data is returned as 3 comma-separated values: occupied bandwidth,
percent of power, dB down.
Syntax: :FETCh:OBWidth?
Cmd Parameter: NA (query only)
Default Unit: OBW in Hz, Percent of Power in %, dB Down in dB
Front Panel
Access: NA