Anritsu MS2026C - Minimum Sweep Time; Actual Sweep Time; Auto Sweep Time

Spectrum Analyzer Commands [:SENSe] Subsystem
MS20xxC PM PN: 10580-00306 Rev. E 6-89
Minimum Sweep Time
[:SENSe]:SWEep:TIME[:LLIMit]
Description: Sets the value of the minimum sweep time parameter. The sweep is
completed in the shortest time possible, greater than the specified time.
To sweep as fast as possible, enter the minimum value that is allowed
for the sweep time.
Syntax: [:SENSe]:SWEep:TIME[:LLIMit]
[:SENSe]:SWEep:TIME[:LLIMit]?
Range: 10 μs to 600000000 μs
Default Value: 1ms
Default Unit: Seconds
Front Panel
Access: Shift-3 (Sweep), Sweep Time
Actual Sweep Time
[:SENSe]:SWEep:TIME:ACTual?
Description: Returns the actual sweep time in seconds as opposed to the specified
sweep time.
Syntax: [:SENSe]:SWEep:TIME[:LLIMit]?
Cmd Parameter: NA (query only)
Query Response: (seconds)
Front Panel
Access: Shift-3 (Sweep), Sweep Time
Auto Sweep Time
Description: Toggles Auto Sweep Time.
Syntax: [:SENSe]:SWEep:TIME:AUTO ON|OFF
[:SENSe]:SWEep:TIME:AUTO?
Cmd Parameter: ON|OFF
Front Panel
Access: Shift-3 (Sweep), Auto Sweep Time