VNA Commands :CALCulate:MARKer Subsystem
MS20xxC PM PN: 10580-00306 Rev. E 3-57
Marker Readout Style
:CALCulate:MARKer<Mk>:FORMat
Description: Sets the specified marker <Mk> readout style. <Mk> is the marker
number in the range of 1 to 8. If no marker number is specified, then the
marker number (the <Mk> value) defaults to 1. <Style> is the
marker readout style and must be one of the following values:
GRAPh|LMAGnitude|LOGPhase|PHASe|RLIMaginary|SWR|
IMPedance||ADMittance|NIMPedance|NADMittance|
PIMPedance|GDELay|LM/2|LINMagnitude|LINPhase
The query version of the command returns “GRAP” if the specified
marker readout style is set to Graph Type, “LMAG” if the specified
marker readout style is set to Log Magnitude, “LOGP” if Log Mag and
Phase, “PHAS” if Phase, “RLIM” if Real and Imaginary, “SWR” if
standing wave ratio, “IMP” for impedance, “ADM” for admittance,
“NIMP” for normalized impedance, “NADM” for normalized
admittance, “PIMP” for polar impedance, “GDEL” if group delay,
“LM/2” for log mag/2 (cable loss), “LINM” for Linear
Magnitude (Lin Mag), and “LINP” for Linear Magnitude and Phase.
Note that the set version of this command sets the specified marker as
the active marker.
Syntax: :CALCulate:MARKer<Mk>:FORMat <Style>
:CALCulate:MARKer<Mk>:FORMat?
Cmd Parameter: <char> <Style> (GRAPh|LMAGnitude|LOGPhase|and so forth)
Query Response: <char> <Style> (GRAP|LMAG|LOGP|and so forth)
Default Value: GRAP
Example: To set marker #3 readout style to Log Mag:
:CALCulate:MARKer3:FORMat LMAG
:CALCulate:MARKer3:FORMat LMAGnitude
:CALC:MARK3:FORM LMAG
Related Command: :CALCulate:MARKer<Mk>:Y?
:CALCulate:MARKer:DATA?
Front Panel
Access: Marker, Readout Style
To Next Page
Loading...
