Spectrum Analyzer Commands :CONFigure Subsystem
MS20xxC PM PN: 10580-00306 Rev. E 6-31
Configure Occupied Bandwidth
:CONFigure:OBWidth
Description: Configures the default occupied bandwidth measurement. Disables any
other active one-button measurements, including channel power,
ACPR, AM/FM demodulation, and C/I. Sets the method to %. Sets the %
of power to 99%. Sets the instrument to single sweep mode
(:INITiate:CONTinuous OFF). Measurement settings can be
modified by using the [:SENSe]:OBWidth commands before initiating
a sweep. Note that this measurement is not valid in zero span.
Syntax: :CONFigure:OBWidth
Related Command: [:SENSe]:OBWidth:STATe
[:SENSe]:OBWidth:METHod
[:SENSe]:OBWidth:PERCent
[:SENSe]:OBWidth:XDB
Front Panel
Access: NA
Measurement Mode
:CONFigure?
Description: Returns the Measurement mode: “CHP” for channel power, “FLDS” for
field strength, “OBW” for occupied bandwidth, “ACP” for ACPR,
“AMFM” for AM/FM Demod, “CI” for C/I.
Syntax: :CONFigure?
Cmd Parameter: NA (query only)
Query Response: NA
Front Panel
Access: NA
To Next Page
Loading...
