Programming with SCPI Parameter Names
MS20xxC PM PN: 10580-00306 Rev. E 2-13
2-11 Parameter Names
The parameters that are returned depend on the firmware version in the MS20xxC, and this
document does not cover all possible parameter values that can be returned by the command.
Parameter names are dependent upon individual applications and are different for each
application. They can be extracted via a Trace Preamble command.
The following tables list the parameter options for the :TRACe:PREamble? command in
each supported measurement mode:
Vector Network Analyzer, refer to:
• Table 3-12, “Trace Header Parameters” on page 3-155.
• Table 3-13, “Trace Header Marker Parameters” on page 3-164
• Table 3-14, “Trace Header Limits Parameters” on page 3-165
Vector Voltmeter, refer to:
• Table 4-4, “Trace Header Parameters” on page 4-9.
Power Monitor, refer to:
• Table 5-2, “Trace Header Parameters” on page 5-3.
Spectrum Analyzer, refer to:
• Table 6-2, “Trace Header Parameters” on page 6-55.
To Next Page
Loading...
