Anritsu MS2026C - Chapter 4-Vector Voltmeter Commands; Introduction

MS20xxC PM PN: 10580-00306 Rev. E 4-1
Chapter 4 — Vector Voltmeter
Commands
4-1 Introduction
This chapter describes commands for Vector Voltmeter mode. Only the commands that are
listed in this chapter and in Chapter 8, “All Mode Commands” can be used in Vector
Voltmeter mode. Using commands from other modes may produce unexpected results.
Notational conventions are described in Section 2-10 “Command and Query Notational
Conventions” on page 2-12.