Anritsu MS2026C - Delta Marker Reference to

:CALCulate:MARKer Subsystem VNA Commands
3-54 PN: 10580-00306 Rev. E MS20xxC PM
Delta Marker Reference To
:CALCulate:MARKer[1]|2|3|4|5|6|7|8:DELTa:REFerence
Description: Sets the specified delta marker reference to the given reference marker
specified by <Mk>. <Mk> is the reference marker number in the range
of 1 to 8. The query version of the command returns the reference
marker number to which the specified delta marker should be
referenced. If the selected marker is not a delta marker, then –230 is
returned. Note that the set version of this command sets the specified
delta marker as the active marker. The given reference marker number
must be currently set as a reference marker, and the specified delta
marker number must currently be set as delta marker. Also, both
markers (delta and reference) must be in the same domain type.
Syntax: :CALCulate:MARKer[1]|2|3|4|5|6|7|8:DELTa:REFerence <Mk>
:CALCulate:MARKer[1]|2|3|4|5|6|7|8:DELTa:REFerence?
Cmd Parameter: <char> <Mk>
Query Response: <char> <Mk>
Default Value: –230 (The selected marker is a reference marker)
Example: Set Marker 1 as the reference marker of delta Marker 3:
:CALCulate:MARKer3:DELTa:REFerence 1
:CALC:MARK3:DELT:REF 1
Related Command: :CALCulate:MARKer<Mk>:TYPE,
:CALCulate:MARKer<Mk>:DOMain?
Front Panel
Access: Marker, Avail Ref Mkr