Anritsu MS2026C - Video Bandwidth to Resolution Bandwidth Ratio; Video Bandwidth

Spectrum Analyzer Commands [:SENSe] Subsystem
MS20xxC PM PN: 10580-00306 Rev. E 6-73
Video Bandwidth to Resolution Bandwidth Ratio
[:SENSe]:BANDwidth|BWIDth:VIDeo:RATio
Description: Sets the ratio of the video bandwidth to the resolution bandwidth for
use when the video-to-resolution bandwidth coupling is enabled. Note
that the front panel interface sets the inverse ratio: the resolution
bandwidth to the video bandwidth, which is an integer. In other words,
if you send 0.35, then the display shows 2 not 2.857.
Syntax: [:SENSe]:BANDwidth|BWIDth:VIDeo:RATio <number>
[:SENSe]:BANDwidth|BWIDth:VIDeo:RATio?
Cmd Parameter: <number>
Query Response: <number>
Range: 0.00001 to 1
Default Value: 0.33
Related Command: [:SENSe]:BANDwidth|BWIDth:VIDeo:AUTO
Front Panel
Access: BW, RBW/VBW (note that this is the inverse ratio)
Video Bandwidth
[:SENSe]:BANDwidth|BWIDth:VIDeo:TYPE
Description: Changes the VBW/Average type.
Syntax: [:SENSe]:BANDwidth|BWIDth:VIDeo:TYPE LOGarithmic|LINear
[:SENSe]:BANDwidth|BWIDth:VIDeo:TYPE?
Default Value: LINear
Related Command: [:SENSe]:BANDwidth|BWIDth:VIDeo:AUTO
Front Panel
Access: BW, VBW/Average Type