Anritsu MS2026C - 3-24 [:Sense]:Correction:ckit Subsystem; Calibration Connector Information

[:SENSe]:CORRection:CKIT Subsystem VNA Commands
3-108 PN: 10580-00306 Rev. E MS20xxC PM
3-24 [:SENSe]:CORRection:CKIT Subsystem
This subsystem provides commands that modify and configure the device under test (DUT).
Calibration Connector Information
[:SENSe]:CORRection:CKIT:INFormation?
Description: Returns a string of information of the given calibration connector.
<connector> defines the connector family and can be given in either
long or short form. [connector-name] is a string that defines the
name that is associated with the given <connector> and is optional.
[connector-name] must be enclosed by parentheses. Note that the
connector must be valid for the current calibration line type.
Note that user 1, user 2, user 3, or user 4 is based on the current
calibration method.
The query response begins with an ASCII header. The header specifies
the number of following bytes. It appears in the format #AX, where A is
the number of digits in X, and X is the number of bytes that follow the
header. Parameters are returned in comma-delimited ASCII format.
Each parameter is returned as “NAME=VALUE[UNITS]”.
The tables below list the available connectors and connector names that
are associated with the calibration line types. Note that Coax User
cal kit and Waveguide do not have a calibration name associated with
them.
Table 3-7. [:SENSe]:CORRection:CKIT Subsystem
Keyword Parameter Data or Units
[:SENSe]
:CORRection
:CKIT
:USER{1-4} Refer to “[:SENSe]:CORRection:CKIT:USER Subsystem”
on page 3-114
COAX
<connector> [connector-name] Description
NMALe OSLN50 N-Conn(M)
Cal Kit: OSLN50.
If no connector-name is given,
information will default to this.
Query Response: <block>
(returns comma-delimted ASCII
format)