Anritsu MS2026C - SCPI Required Commands; SCPI Optional Commands

Programming with SCPI SCPI Required Commands
MS20xxC PM PN: 10580-00306 Rev. E 2-3
2-4 SCPI Required Commands
The required SCPI commands that are supported by the MS20xxC are listed in the Table 2-1.
These commands work in all measurement modes and are described in Chapter 3 on page 3-1
2-5 SCPI Optional Commands
Table 2-2 lists the optional SCPI commands that comprise the majority of the command set
that is described in this document. These commands control most of the programmable
functions of the MS20xxC.
The SCPI optional commands are sorted by measurement modes, and commands may be
repeated in more than one mode.
• Chapter 3, “VNA Commands”
• Chapter 4, “Vector Voltmeter Commands”
• Chapter 5, “Power Monitor Commands”
• Chapter 8, “All Mode Commands”
Table 2-1. SCPI Required Commands
:STATus
:SYSTem
Table 2-2. SCPI Optional Commands
:ABORt
:CALCulate
:CALibration
:DISPlay
:FETCh
:FORMat
:INITiate
:INPut
:INSTrument
:MEASure
:MMEMory
:SENSe
:SOURce
:TRACe
:UNIT
:[SENSe]