Spectrum Analyzer Commands :TRACe Subsystem
MS20xxC PM PN: 10580-00306 Rev. E 6-63
Trace B Operation
:TRACe2:OPERation
Description: This command specifies how successive traces are combined to produce
the resulting display values.
Setting the operation to MAXHold is equivalent to pressing
Shift-5 (Trace), Trace B Operations, Max Hold→B on the front panel.
This displays the largest signal for each display point over multiple
sweeps.
Setting the operation to MINHold is equivalent to pressing
Shift-5 (Trace), Trace B Operations, Min Hold→B on the front panel. This
displays the smallest signal for each display point over multiple sweeps.
The query version of the command returns the current operation mode
or “NONE” if no operation is set.
Syntax: :TRACe2:OPERation MAXHold|MINHold
:TRACe2:OPERation?
Cmd Parameter: <char> MAXHold|MINHold
Query Response: <char> MAXH|MINH
Range: MAXHold|MINHold
Default Value: None
Front Panel
Access: Shift-5 (Trace), Trace B Operations, Max Hold→B
Shift-5 (Trace), Trace B Operations, Min Hold→B
To Next Page
Loading...
