Anritsu MS2026C - Chapter 6-Spectrum Analyzer Commands; Introduction; Spectrum Analyzer Commands

MS20xxC PM PN: 10580-00306 Rev. E 6-1
Chapter 6 — Spectrum Analyzer
Commands
6-1 Introduction
This chapter describes commands for Spectrum Analyzer mode. Only the commands that are
listed in this chapter and in Chapter 8, “All Mode Commands” can be used in Spectrum
Analyzer mode. Using commands from other modes may produce unexpected results.
Notational conventions are described in Section 2-10 “Command and Query Notational
Conventions” on page 2-12.
Spectrum Analyzer Commands
Table 6-1. SPA Commands Subsystems
Keyword Parameter Data or Units
:ABORt “:ABORt Subsystem” on page 6-2
:CALCulate “:CALCulate Subsystem” on page 6-3
:CONFigure “:CONFigure Subsystem” on page 6-29
:DISPlay “:DISPlay Subsystem” on page 6-32
:FETCh “:FETCh Subsystem” on page 6-34
:FORMat “:FORMat Subsystem” on page 6-37
:INITiate “:INITiate Subsystem” on page 6-39
:MEASure “:MEASure Subsystem” on page 6-41
:MMEMory “:MMEMory Subsystem” on page 6-46
:READ “:READ Subsystem” on page 6-50
:SENSe “[:SENSe] Subsystem” on page 6-68
:TRACe “:TRACe Subsystem” on page 6-53
:TRIGger “:TRIGger Subsystem” on page 6-65
:UNIT “:UNIT Subsystem” on page 6-67
[:SENSe] “[:SENSe] Subsystem” on page 6-68