Anritsu MS2026C - Trace Header Transfer

:TRACe Subsystem Spectrum Analyzer Commands
6-54 PN: 10580-00306 Rev. E MS20xxC PM
Trace Header Transfer
:TRACe:PREamble?
Description: Returns trace header information for the specified trace. Data can be
transferred to and from the 3 available display traces. Use the
commands in the :MMEMory subsystem to store and recall traces from
the instrument memory. The response begins with an ASCII header.
The header specifies the number of following bytes. It appears as #AX,
where A is the number of digits in X, and X is the number of bytes that
follow the header. (Refer to “Example Response Format:” on page 3-154
for an example of the header.)
Parameters are returned in comma-delimited ASCII format. Each
parameter is returned as “NAME=VALUE[UNITS],” Note that the
parameters that are returned depend on the firmware version, and that
this document does not cover all parameter values that are returned by
the command. Refer to Table 6-2 for valid parameter names.
Syntax: :TRACe:PREamble? {1|2|3}
Cmd Parameter: NA (query only)
Query Response: [1]|2|3
Range: 1|2|3
Front Panel
Access: NA