Anritsu MS2026C - 6-10:Mmemory Subsystem; Recall Limit; Recall Setup

:MMEMory Subsystem Spectrum Analyzer Commands
6-46 PN: 10580-00306 Rev. E MS20xxC PM
6-10 :MMEMory Subsystem
The Mass MEMory subsystem contains functions that provide access to the instrument setup
and data storage.
Recall Limit
:MMEMory:LOAD:LIMit
Description: Recalls a previously stored limit from the current storage location. The
saved limit setting that is to be loaded is specified by <file name>.
<file name> should be enclosed in either single quotes (‘ ’) or double
quotes (“ ”) and should contain a file extension “.lim”. Note that the
trace specified by <file name> should be available at the current
mass storage location. Use the command :MMEMory:MSIS to set the
current mass storage location. File Extensions: “.lim”
Syntax: :MMEMory:LOAD:LIMit <file name>
Cmd Parameter: <file name>
Example: To recall trace with file name “limit”:
:MMEMory:LOAD:LIMit “limit.lim”
Related Command: :MMEMory:STORe:LIMit
Front Panel
Access: Shift-7 (File), Recall, Change Type (select file type from list)
Recall Setup
:MMEMory:LOAD:STATe
Description: Recalls a previously stored instrument setup in the current storage
location. The setup file that is to be loaded is specified by
<file name>. <file name> should be enclosed in either single
quotes (‘ ’) or double quotes (“ ”) and should contain a file extension
“.stp”. Use the command :MMEMory:MSIS to set the current storage
location. The <integer> parameter is not currently used, but it must
be sent.
Send a numeral 1.
Syntax: :MMEMory:LOAD:STATe <integer>,<file name>
Cmd Parameter: <integer>, <file name>
Related Command: :MMEMory:STORe:STATe
:MMEMory:MSIS INTernal|USB
Front Panel
Access: Shift-7 (File), Recall, Change Type (select file type from list)