WindO/I-NV4 User’s Manual 31-7
1 External Memory Devices
31
External Memory Devices
● Using WindO/I-NV4 to read and write to an external memory device inserted in the computer
Insert an external memory device
*1
into the USB port or memory card slot of your computer, or via a docking station,
etc.
Communication settings
To read and write to the external memory device inserted in the computer using WindO/I-NV4, the external memory
device must be specified as the communication device. Configure the communication settings as follows before
downloading or uploading.
1 On the Home tab, in the Project group, click Comm. Setup.
The Communication Settings dialog box appears.
2 Under Communicate with, select External Memory Device, then click OK.
*1 USB flash drive inserted in USB1 for HG2J-7U, SD memory card for HG5G/4G/3G/2G-V, HG4G/3G and HG2G-5F,
USB flash drive for HG2G-5T and HG1G/1P
Computer
Via a docking station etc.
SD memory card
Into SD memory card slot
Into USB port
USB flash drive
SD memory card
USB flash drive
To Next Page
Loading...