WindO/I-NV4 User’s Manual 10-189
10 Numerical Display
10
Data Displays
■ Display Method
Specifies the source of the value to display.
*1 Advanced mode only
Display Device Address: Specifies the word device that stores the value to display.
Click to display the Tag Editor. For the device address configuration procedure,
refer to Chapter 2 “5.1 Device Address Settings” on page 2-70.
Use Reference Device Address
*1
:
Select this check box and specify a device address to change the source device
address by the value of this device address.
Click to display the Tag Editor. For the device address configuration procedure,
refer to Chapter 2 “5.1 Device Address Settings” on page 2-70.
For details on indirect reading, refer to Chapter 2 “Indirect Read and Indirect Write
Settings” on page 2-5.
To Next Page
Loading...