WindO/I-NV4 User’s Manual 2-51
3 Configuration & Functions
2
WindO/I-NV4 Features & Basic Operations
â– Monitors
â– Simulator
â– Communication
Command Description
Start/Stop Monitor
Starts or stops monitoring the MICRO/I with WindO/I-NV4. An external device
is required when configuring it.
Go Offline/Online
Switch the MICRO/I to Offline Mode or Online Mode. Under Offline Mode, you
can change values of device addresses with WindO/I-NV4 and check the
operation of project data on the MICRO/I.
Screens Shows or hides the Screen Monitor window.
Object List
Displays a value of device address in a popup and emphasizes the object that
is satisfying the trigger condition in the object list or script editor.
Custom Shows or hides the Custom Monitor window.
Batch Shows or hides the Batch Monitor window.
External Devices
Shows or hides the External Device Monitor window during 1:N
communication.
Open Current Screens Opens a monitored screen in the editing window.
Back
Returns to the Base Screen that was displayed immediately before the screen
was changed.
Forward
Advances to the Base Screen that was displayed immediately before the
screen was changed with the Back command.
Go to
Screen
First Screen Switches to the Base Screen with the smallest screen number in the project data.
Previous Screen
Switches to the Base Screen with a screen number one smaller than the Base
Screen currently displayed. If the screen numbers are not consecutive
numbers, this command switches to the closest number.
Screen Number Switches to the Base Screen with a specified number.
Next Screen
Switches to the Base Screen with a screen number one larger than the Base
Screen currently displayed. If the screen numbers are not consecutive
numbers, this command switches to the closest number.
Last Screen
Switches to the Base Screen with the largest screen number in the project
data.
Command Description
Simulator
Launch Simulator.
Load Value of Device Address
(External Device, LK, LKR)
and Run
Load the project data, and the values of device addresses on the external
devices, HMI Keep Relays (LK), and HMI Keep Registers (LKR), and then
launch Simulator.
Clear Value of Device Address
(External Device, LK, LKR)
and Run
Clear Value of Device Address (External Device, LK, LKR) and Run
Command Description
Setup
Configures the communication target and communication conditions between
the target and the MICRO/I or between the computer and the MICRO/I.
To Next Page
Loading...
General