WindO/I-NV4 User’s Manual 12-51
6 Multi-Command
12
Commands
Upload Project is selected.
*1 HG5G/4G/3G/2G-V, HG4G/3G, HG2G-5F only
*2 HG5G/4G/3G/2G-V, HG4G/3G, HG2G-5F/-5T, HG1G/1P only
*3 HG2J-7U only
Destination: Specify where to save the project uploaded from MICRO/I. Select the location:
SD Memory Card
*1
, USB Flash Drive
*2
, USB1
*3
or USB2
*3
.
Location: Specify the location where the uploaded project will be saved. The maximum number is 247
characters. Only alphanumeric characters and symbols can be used. Path delimiters and
characters that cannot be used vary based on the model.
Example: To save a project to the folder “Uploaded_Project” in an external memory device:
Uploaded_Project
Model
HG2J-7U
HG5G/4G/3G/2G-V, HG4G/3G, HG2G-5F/-5T, HG1G/1P
Delimiter Characters that cannot be used
" # $ & ' ( ) * : ; < > ? \ ` | ~
" * : ; < > ? |
/
\
A uploaded project using the Data Transfer function is saved as a ZNV Project File(.znv).
To Next Page
Loading...
General