EasyManuals Logo

IDEC WindO/I-NV4 User Manual

IDEC WindO/I-NV4
1738 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #976 background imageLoading...
Page #976 background image
6 Multi-Command
12-52 WindO/I-NV4 User’s Manual
Copy Files
*4
is selected.
*1 HG5G/4G/3G/2G-V, HG4G/3G, HG2G-5F only
*3 HG2J-7U only
*4 HG2J-7U, HG5G/4G/3G/2G-V, HG4G/3G , HG2G-5F only
Source:
Select the source external memory: SD Memory Card
*1
, USB Flash Drive
*1
, USB1
*3
or USB2
*3
.
Location: Specify the location of the file to be transferred. The maximum number is 247 characters.
Only alphanumeric characters and symbols can be used. Path delimiters and characters that
cannot be used vary based on the model.
Example: Copy a file “Error.wav” to the root directory of an external memory device:
Error.wav
Destination:
Select the destination external memory: SD Memory Card
*1
, USB Flash Drive
*1
, USB1
*3
or
USB2
*3
.
Location: Specify the location where the file will be transferred. The maximum number is 247
characters. Only alphanumeric characters and symbols can be used. Path delimiters and
characters that cannot be used vary based on the model.
Example: Save a file to the “SOUND” folder under “HGDATA01” folder in an external
memory device:
HG2J-7U: HGDATA01/SOUND
HG5G/4G/3G/2G-V, HG4G/3G, HG2G-5F: HGDATA01\SOUND
Model
HG2J-7U
HG5G/4G/3G/2G-V, HG4G/3G, HG2G-5F
Delimiter Characters that cannot be used
" # $ & ' ( ) * : ; < > ? \ ` | ~
" * : ; < > ? |
/
\
Model
HG2J-7U
HG5G/4G/3G/2G-V, HG4G/3G, HG2G-5F
Delimiter Characters that cannot be used
" # $ & ' ( ) * : ; < > ? \ ` | ~
" * : ; < > ? |
/
\
If a file name is specified as the source location, the specified file is copied.
If a folder name is specified, all of the files and subfolders contained in the folder, and all of the files in
the subfolders, are copied.
The subfolders can be copied up to five levels.
To prevent copying the subfolders and the files contained in the subfolders, HMI Special Internal Relay
LSM30 must be set to 1 before executing the copy.
To stop copying files during the copy operation, write 1 to HMI Special Internal Relay LSM31. However, it
will continue to copy the file until it is finished then it will stop copying.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the IDEC WindO/I-NV4 and is the answer not in the manual?

IDEC WindO/I-NV4 Specifications

General IconGeneral
BrandIDEC
ModelWindO/I-NV4
CategoryOrganizer
LanguageEnglish