TEDS 241
imc CANSAS Users Manual - Doc. Version 1.9 - 05.12.2014© 2014 imc Meßsysteme GmbH
5.8.2.4.2 Exchanging sensor information between the sensor-Eprom and sensor
database
With a module selected in imc CANSAS, the Sensors page in its dialog appears as follows:
The pop-down selection list determines which sensor information is imported or exported.
5.8.2.4.3 Read Sensor-Eprom
to imc-Sensors: Exports sensor-Eprom contents to the database imc SENSORS. imc SENSORS must be
already open.
to XML-file: Exports information from sensor-Eprom and saves it to a file in XML-format. By this means,
information from individual sensors can easily be exchanged.
5.8.2.4.4 Write Sensor-Eprom
from imc-Sensors: The database imc SENSORS is open and a sensor is already selected. The information
on the selected sensor is written to the sensor Eprom.
out of XML-file: Sensor information stored in an XML-file is written to the sensor Eprom.
To Next Page
Loading...
