240 Measurement Technique
imc CANSAS Users Manual - Doc. Version 1.9 - 05.12.2014© 2014 imc Meßsysteme GmbH
The sensor information is only applied if the channel supports the corresponding properties. Otherwise,
an error message is posted:
Notes to characteristic curves
When importing characteristic curves from TEDS or imc SENSORS to imc CANSAS, the characteristic
curve may not comprise more than 60 measured points. If an attempt is made to import a
characteristic curve with more than 60 measured points, a corresponding error message appears.
As of imc CANSAS Version 1.6R6, characteristic curves are also accepted if the curve's X-values
decrease strictly monotonically. Previously, only characteristic curves with strictly monotonically
increasing X-values were permitted.
To Next Page
Loading...
