Lexmark X945e MFP 7510 series User Manual

2-194 Service Manual
7510
Go Back
Previous
Next
951.XX RIP card assembly NVRAM failure
952.XX Interconnect card assembly NVRAM CRC failure
Step Check Yes No
1 Check the interconnect card assembly.
Was the interconnect card assembly recently replaced?
Go to step 3. Go to step 2.
2 Check the RIP card assembly.
Was the RIP card assembly recently replaced?
Go to step 4. Contact the next
level of support.
3 Replace the current interconnect card assembly with the
original interconnect card assembly.
Does the error remain?
Go to step 5 Problem solved.
4 Replace the current RIP card assembly with the original RIP
card assembly.
Go to “Interconnect card assembly removal” on
page 4-86.
Does the error remain?
Go to step 6. Problem solved.
5 If problem remains, replace the original interconnect card
assembly with a new and not previously installed
interconnect card assembly.
Does the error remain?
Contact the next
level of support.
Problem solved.
6 If problem remains, replace the original panel assembly with
a new and not previously installed interconnect card
assembly.
Go to “Interconnect card assembly removal” on
page 4-86.
Does the error remain?
Contact the next
level of support.
Problem solved.
Step Check Yes No
1 Perform a POR.
Does the error occur when the power is turned off/on?
Go to step 2. Perform several
print tests.
If the problem
remains, go to
step 2.
2 Turn the printer off for 60 seconds.
Does the error occur when the power is turned off/on again?
Replace the RIP
card assembly.
Go to “RIP card
assembly
removal” on
page 4-84.
Go to step 3.
Problem solved.
Step Check Yes No
1 Perform a POR.
Does the error occur when the power is turned off/on?
Go to step 2. Perform several
print tests.
If the problem
remains, go to
step 2.

Lexmark X945e MFP 7510 series Specifications

General

Brand	Lexmark
Model	X945e MFP 7510 series
Category	Printer
Language	English