3-50 Service Manual
7510
Key Repeat Initial Delay
When a key is touched repeatedly, this is the delay before the key begins repeating. The delay ranges from .25
seconds to 5 seconds. The default is 1 second. Values are given in increments of .25 seconds.
To change this setting:
1. Touch Key Repeat Initial Delay from the Configuration Menu.
2. Touch to increase the value or to decrease the value.
3. Touch Submit to save the change.
4. Touch Back to cancel and return to the Configuration Menu.
Key Repeat Rate
This is the number of times per second that a repeating key will repeat. The range is 1–100, with a default of 15
times per second.
To change this setting:
1. Touch Key Repeat Initial Delay from the Configuration Menu.
2. Touch to increase the value or to decrease the value.
3. Touch Submit to save the change.
4. Touch Back to cancel and return to the Configuration Menu.
Exiting Configuration Menu
From the Configuration Menu, touch Back until a graphic appears with Exit Config Menu in the lower right
corner. Touch Exit Config Menu to exit the Configuration Menu. Resetting the Printer appears on the LCD.
The printer performs a POR, and the following graphic appears on the LCD:
Copy
E-Mail
Fax
FTP
Menus
Ready. Toner low.
Touch any button to begin.
Status/
Supplies
To Next Page
Loading...
Need help?
General
