Repair information 4-185
7510
2000-sheet dual input (TTM)—tray 4 front cables removal
1. Remove the TTM media tray 4 assembly. See “2000-sheet dual input (TTM)—TTM media tray 4
assembly removal” on page 4-177.
2. Remove the tray 4 front cover. See “2000-sheet dual input (TTM)—TTM media tray 4 front cover
removal” on page 4-182.
3. Place the TTM media tray 4 assembly on its right side, as shown in the figure.
4. Remove the E-clip with a prying tool securing the front tray lift pulley (A) to the tray lift shaft assembly (B).
5. Remove the front tray lift pulley (A).
Note: The tray 4 front cables (C) become detached.
6. Remove the tray 4 front cables (C) from the tray lift shaft assembly (B).
7. Place the TTM media tray 4 assembly back in its upright position.
8. Remove two E-clips with a prying tool securing the two small pulleys (D) on the front of the frame assembly.
9. Remove the two small guides (E) and the two small pulleys (D).
To Next Page
Loading...
