Lexmark X945e MFP 7510 series - 500-Sheet Drawer (3 TM)-Media Feed Lift Motor Removal

4-224 Service Manual
7510
Go Back
Previous
Next
7. Remove the sensor (tray 3 feed-out) (B).
3X 500-sheet drawer (3TM)—media feed lift motor removal
1. Remove the media feed unit assembly. See“3X 500-sheet drawer (3TM)—media feed unit assembly
removal (tray 2)” on page 4-222 or “3X 500-sheet drawer (3TM)—media feed unit assembly removal
(tray 3)” on page 4-220.
2. Disconnect the harness from the media feed lift motor (A).
3. Remove the two screws securing the media feed lift motor to the media feed unit assembly (B).
4. Remove the media feed lift motor (B).
A
B
Connector
Rear