Diagnostic information 2-205
7510
Paper is installed (short edge) in the media paper tray
3
Check the sensor (media out) connection for proper
connection on the appropriate media tray.
Is the above component connected properly?
Replace the
appropriate sensor
(media out).
Go to “1X 500-
sheet drawer
(1TM)—sensor
(media out)
removal” on
page 4-250, “3X
500-sheet drawer
(3TM)—sensor
(media out)
removal” on
page 4-228, or
“2000-sheet dual
input (TTM)—
sensor (media
out) removal” on
page 4-199.
Replace the
connection.
4
Perform a POR.
Does the error continue when the power is turned off/on?
Replace the upper
printer engine card
assembly.
Go to “Upper
printer engine
card assembly
removal” on
page 4-88.
Problem solved.
Step Check Yes No
1 Is the media installed (short edge) orientation in the media
tray assembly as opposed to long edge?
Turn media 90
degrees or enable
short edge feeding
which is found in
the config menu
(press select and
right arrow at
power on), and
then find the menu
item short edge
printing.
Go to step 2.
2
Perform a print test.
Does the error remain?
Replace the
printer engine card
assembly.
Go “Upper
printer engine
card assembly
removal” on
page 4-88.
Problem solved.
Step Check Yes No
To Next Page
Loading...
Need help?
General
