3-40 Service Manual
7510
A5/Statement
Due to engine limitations, Trays 1 through 4 cannot simultaneously sense A5- and statement-size paper. The
value of this setting determines which of the two paper sizes these trays will sense automatically. This setting
will apply to all automatic trays, but not to the MP Feeder. The MP Feeder can support these paper sizes
regardless of the value of this setting.
B5/Executive
Due to engine limitations, Trays 1 through 4 cannot simultaneously sense executive and JIS-B5-size paper. The
value of this setting determines which of the two paper sizes these trays will sense automatically. This setting
will apply to all automatic trays, but not to the MP Feeder. The MP Feeder can support these paper sizes
regardless of the value of this setting.
Panel Menus
Selections are to Disable or Enable (default) operator panel menus.
To change the value of this setting:
1. Touch Panel Menus from the Configuration Menu. [setting's current value] appears on the touch-
screen.
2. Touch or to scroll through the setting's other possible values.
3. Touch Back to cancel and return to the Configuration Menu.
4. Touch Submit to save the change.
PPDS Emulation
The value of the PPDS Emulation menu item determines if a device can recognize and use the PPDS
datastream. The current value of this setting appears in parentheses to the right of the setting on the
Configuration Menu screen.
The following table indicates how the value of this setting affects the user default value for the Smartswitch and
Printer Language settings:
To change the value of this setting:
1. Touch PPDS Emulation from the Configuration Menu. [setting's current value] appears on the
touch-screen.
2. Touch or to scroll through the setting's possible values.
3. Touch Back to cancel and return to the Configuration Menu.
4. Touch Submit to save the change.
Value of
PPDS
Emulation
setting
Resulting value of
Smartswitch setting
(all ports)
Resulting value for Printer Language settings
Activate Off PPDS Emulation
Note: You can still switch languages on the operator panel or through
the PJL ENTER LANGUAGE command.
Deactivate On Printer's factory default value
To Next Page
Loading...
Need help?
General
