NEC Xen Master - 1-1-55 DID Line Ringing Pattern Selection

DID Line Ringing Pattern Selection 1 - 87
Programming Manual May 2003
A6-324000-642-02 - Release 6.0 May 2003
1-1-55
System Mode
1
Submode
1
Data No.
55
PC Programming
a
+ALN
DID Line Ringing Pattern Selection
General Description
This Memory Block assigns the ringing pattern to be used for DID calls.
Display
Settings
LK 1 LK 2 LK 3 LK 4
Ring Pattern
A
Ring Pattern
B
Ring Pattern
C
Ring Pattern
D
LK 5 LK 6 LK 7 LK 8
Ring Pattern
E
Ring Pattern
F
Ring Pattern
G
Ring Pattern
H
The shaded area indicates the default setting.
LK 9 LK 10 LK 11 LK 12
No ring
LK 13 LK 14 LK 15 LK 16
Programming Procedures
1 Go off-line.
2 Press LK1 + LK1 +
EE to access the Memory Block.
3 Press the corresponding CO/PBX line key to change the data option.
Note: Use the following to change page:
S to move to next page
T to move to previous page
4 Press
Nto write the data.
5 Press
Pto go back on-line.
Related Programming
M.B. Number Memory Block Name
1-1-20
DID Digit Length Selection
1-1-21
DID Digit Conversion Assignment
1-1-22
DID Digit Conversion Table & DNIS Assignment
5 5 : D I D P T N C | 1
T I M E D I S P L A Y
Data
No.
Title
Setting
Data
Page
No.