First to Second Delay Announcement Interval Time Selection 1 - 105
Programming Manual May 2003
A6-324000-642-02 - Release 6.0
May 2003
1-1-73
System Mode
1
Submode
1
Data No.
73
PC Programming
a
+AR
First to Second Delay
Announcement Interval Time
Selection
General Description
Use this Memory Block to specify the interval time between the end of the First Delay
Announcement sending time and the start time of the Second Delay Announcement.
Display
Settings
LK 1 LK 2 LK 3 LK 4
The shaded area indicates the default setting.
0 sec. 10 sec. 20 sec. 30 sec.
LK 5 LK 6 LK 7 LK 8
40 sec. 50 sec. 60 sec. No Limit
Programming Procedures
1 Go off-line.
2 Press LK1 + LK1 +
GC to access the Memory Block.
3 Press the corresponding CO/PBX line key to change the data option.
4 Press
Nto write the data.
5 Press
Pto go back on-line.
Related Programming
M.B. Number Memory Block Name
1-1-74
Second Delay Announcement Repeat Selection
1-1-75
Second Delay Announcement Repeat Interval Time Selection
1-8-13
VRS Message Recording Time Selection
3-41
ACD/UCD Delay Announcement Assignment
N
This Memory Block does not display unless the MIFA-U13 ETU is installed.
7 3 : M S G I N T V L = 2 0
T I M E D I S P L A Y
Data
No.
Setting
Data
Title
To Next Page
Loading...
Need help?
General
