Intercom Master Hunt Number Selection 1 - 337
Programming Manual May 2003
A6-324000-642-02 - Release 6.0
May 2003
4-14
System Mode
4
Submode
—
Data No.
14
PC Programming
a
+BTT
Intercom Master Hunt Number
Selection
General Description
Use this memory block to assign a master intercom number to each telephone.
Display
Settings
LK 1LK 2LK 3LK 4
The shaded area indicates the default setting.
No Yes
LK 5 LK 6 LK 7 LK 8
Programming Procedures
1 Go off-line.
2 Press LK4 +
AD to access the Memory Block.
3 Press the corresponding CO/PBX line key to change data option
Note: Use the following to change option:
Rto move to the next Tel Port No.
4 Press
Nto write the data.
5 Press
Pto go back on-line.
Related Programming
M.B. Number Memory Block Name
4-15
Intercom Master Hunt Number Forward Assignment
N
1. If Yes is assigned, an incoming internal call from another station, Automated Attendant transferred call, or DIT/ANA/
DID/Tie line designated call is forwarded to a station specified in Memory Block 4-15 Intercom Master Hunt Number
Forward Assignment if line is busy.
2. Telephone ports A0~C0 are ports 100~120.
0 1 / 1 4 : M S T E R N O
T I M E D I S P L A Y
Data
No.
Tel Port
No.
(01~99)
A0~C0
Setting
Data
Title
To Next Page
Loading...
