NEC Xen Master Programming Manual

Voice Prompt to Tone Assignment 1 - 211
Programming Manual May 2003
A6-324000-642-02 - Release 6.0 May 2003
1-8-16
System Mode
1
Submode
8
Data No.
16
PC Programming
a
+AR
Voice Prompt to Tone Assignment
General Description
Use this Memory Block to assign the voice prompt to each tone. Voice prompt is provided
only during the Internal Dial tone or Call Waiting tone.
Display
Settings
LK 1LK 2LK 3LK 4
The shaded area indicates the default setting.
Voice
Prompt 1
Voice
Prompt 2
LK 5 LK 6 LK 7 LK 8
Programming Procedures
1 Go off-line.
2 Press LK1 + LK8 +
AFto access the Memory Block.
3 Press corresponding CO/PBX line key to change data option.
Note: Table No. 1: Dial tone
Table No. 2: Call Waiting tone
Default Values
Dial Tone: Voice Prompt 1
Call Waiting Tone: Voice Prompt 2
4 Press
Nto write the data and advance to Table 02.
5 After entering last data, press
Nto write the data.
6 Press
Pto go back on-line.
Related Programming
M.B. Number Memory Block Name
Refer to Chapter 2 Guide to Feature Programming.
1 6 : 0 1 : D T = P R 1
T I M E D I S P L A Y
Data
No.
Setting
Data
Table
No.
Tone
Name

NEC Xen Master Specifications

General

Brand	NEC
Model	Xen Master
Category	Telephone
Language	English